i took off the center cap, and unscrewed the center bolt. I took out all the plastic agitators. underneath, there was ton of scum i cleaned out. but there was 4 heavily rusted bolts there. are they a problem? also, should I try to take them out and replace them?I have a Maytag Proforma washing machine with some rusted bolts. are they an issue.?
Is the machine operating properly at the present time? Are there any other related problems? i.e. malfunctioning agitator.
They may be rusted to the point where it may be very difficult to remove them anyway.
Depending on the particular clamp up, there may also be a nut on the other end.
If there is only surface rusts on the heads, you may be wasting your time. Unless these are critical bolts, it wouldn't be worth your time or effort.I have a Maytag Proforma washing machine with some rusted bolts. are they an issue.?
no they should be fine if the bolts r in the way remove them and replace them if u need that way u can clean it when u have to
most washers get rust in them somewhere
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment